Using The Setup Command Facility; Before Starting Your Router - Cisco 2620 Configuration Manual

Using the Setup Command Facility

This chapter describes how to use the setup command facility to configure your router. The setup
command facility prompts you to enter information needed to start a router functioning quickly. The
facility steps you through a basic configuration, including local-area network (LAN) and wide-area
network (WAN) interfaces. The following sections are included:
•
•
•
•
•
•
If you prefer to configure the router manually or you wish to configure a module or interface that is not
included in the setup command facility, proceed to
Interface,"

Before Starting Your Router

Before you power on your router and begin to use the setup command facility, make sure you follow
these steps:
Step 1
Set up the hardware as described in the documentation appropriate to your router.
Step 2
Configure your PC terminal emulation program for 9600 baud, 8 data bits, no parity, and 1 stop bit.
Step 3
Determine which network protocols you are supporting (for example, AppleTalk, IP, Novell IPX, and
so on).
Step 4
Determine the following for each network protocol:
•
•
OL-1957-04
Before Starting Your Router, page 2-1
Using the setup Command Facility, page 2-2
Configuring Global Parameters, page 2-2
Configuring Interface Parameters, page 2-5
Completing the Configuration, page 2-23
Where to Go Next, page 2-24
for step-by-step instructions.
Addressing plan
Which WAN protocols you will run on each interface (for example, Frame Relay, HDLC, X.25, and
so on)
Software Configuration Guide for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers
C H A P T E R
"Chapter 3, "Configuring with the Command-Line
2
2-1