Programming The Discrete Contact Points; Verifying The Ip Address - Cisco 2620 Configuration Manual

Chapter 3 Configuring with the Command-Line Interface

Programming the Discrete Contact Points

The discrete alarms do not require as much programming as the analog alarms. The AIC CLI commands
available are the following:
Command
no
exit
description
normally
level

Verifying the IP Address

To verify that the correct AIC IP address and IP route was entered, use the show run command. Below
are samples of before-configuration and after-configuration show run command outputs:
interface Serial5/0
ip unnumbered FastEthernet0/0
!
ip route 10.2.130.102 255.255.255.255 Serial5/0
!
alarm-interface 5
ip address 10.2.130.102
********Before Configuration show run Output*******
version 12.1
no service single-slot-reload-enable
service timestamps debug uptime
service timestamps log uptime
no service password-encryption
!
hostname uut2-3660
!
logging rate-limit console 10 except errors
!
ip subnet-zero
!
!
no ip finger
no ip domain-lookup
!
call rsvp-sync
cns event-service server
!
!
interface FastEthernet0/0
ip address 10.2.130.2 255.255.0.0
duplex auto
speed auto
no cdp enable
OL-1957-04
Software Configuration Guide for Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Routers
Configuring the NM-AIC-64, Contact Closure Network Module
Description
Reversal option
Exits current mode
Sets the description. If no is set, then the description
is not required.
Sets the alarm's normal state to closed. If the no
option is used, the normal state is set to open. This
command applies only to points 1 - 56.
Sets the alarm's level to the specified level.
3-43