Denon AVR-889 Owner's Manual page 54

ENGLISH
Symbols used to indicate buttons in this manual
Button located on both the main unit
and the remote control unit
Button only on the main unit
Button only on the remote control unit
<SOURCE SELECT> <STATUS>
<ON/STANDBY>
[Front]
[OFF]
[iPod]
[1]
[6, 7]
[8, 9]
uiop
[SOURCE
CONTROL 1]
[Rear]
[iPod]
[TUNING +/–]
[MODE]

iPod ® Playback
The music on an iPod can be played by using the control dock for
iPod (ASD-1R, ASD-11R, ASD-3N or ASD-3W sold separately).
BUTTON
The operation can also be performed using the buttons on the main
<BUTTON>
unit or remote control unit while watching the menus.
[BUTTON]
iPod is a trademark of Apple Inc., registered in the U.S.
and other countries.
ui
b The iPod may only be used to copy or play contents that are not
copyrighted or contents for which copying or playback is legally
permitted for your private use as an individual. Be sure to comply
with applicable copyright legislation.
Basic Operation
1
Make the necessary preparations.
ENTER, op q S et the iPod in the DENON control dock for iPod.
(vSee the control dock for iPod's operating instructions.)
w Assign the control dock for iPod's input.
The input for the control dock for iPod is assigned to VCR by
default.
MENU : "Input Setup" – "Assign" – "iPod Dock"
(vpage 34)
[2]
2
Either turn
select the input source assigned in step 1-w above.
ENTER
[SOURCE
b If the screens above are not displayed, the iPod may not be
CONTROL 2]
properly connected. Try connecting again.
3
[SOURCE CONTROL 1]
Set
CONTROL 2]
(vpage 56 "Remote Control Unit Operations")
uiop
ENTER
<SOURCE SELECT> [iPod]
or press
OK to disconnect.
(iPod screen)
[SOURCE
to "AUDIO" and
to "iPod/NETWORK".
4
[MODE]
Press and hold it down for a 2 seconds or
more to select the display mode.
To switch between modes, press and hold down the button.
When remote mode is active, "Remote" is displayed.
[Selectable mode] Browse mode
Display location Main unit display
Audio file
Playable
files
Video file
Remote
control unit
Active
(AVR-889)
buttons
iPod
z 1 : When using an ASD-3N or ASD-3W control dock for iPod
z 2 : Video may not be output, depending on the combination of ASD-1R
or ASD-11R and iPod.
• With the default settings, the iPod can be used connected to the
VCR (iPod) connector.
• Use the RESTORER mode to expand the low and high frequency
components of compressed audio fi les and achieve a richer sound.
The default setting is "Mode3" (vpage 43).
<ON/STANDBY> [OFF]
• Press or and set the AVR-889's power to the
standby mode before disconnecting the iPod. Also switch the input
source to one to which the menu "iPod Dock" is not assigned before
to
disconnecting the iPod.
• When using an ASD-3N or ASD-3W control dock for iPod, refer to
the respective manual to operate.
Remote mode
iPod display
S S
S z 1 S z 2
S S
A S
.