Parental Lock; Checking The Sirius Signal Strength And Radio Id - Denon AVR-889 Owner's Manual

• The channel switches continuously when
held.
• The song title, artist name, composer name, category and reception
<STATUS>
level can be checked by pressing
• The time (default : 30 sec) for which the on-screen display are
displayed can be set at menu "Manual Setup" – "Option Setup"
– "On-Screen Display" (vpage 29).
Press uio p to return to the original screen.
Checking the SIRIUS Signal Strength
and Radio ID
1
<SOURCE SELECT>
Either turn or press
to select "SIRIUS".
2
<STATUS>
Press until "SIGNAL" appears on the
display.
The display will switch as shown below, depending on the
reception conditions.
Display Status
EXCELLENT Signal strength is excellent
GOOD Signal strength is good
WEAK Signal strength is weak
NO SIGNAL No signal
3
Adjust the position of the antenna until "SIGNAL:
EXCELLENT" is shown on the display.
4
<STATUS>
Press until the channel you want to check
(example: "SR001") is displayed.
5
TUNING
Press and select channel 0 (SR000).
Channel No. and Sirius ID are alternately shown on the display.
SR000 SiriusID
Radio ID
************
b
Write your own SIRIUS ID for storage use.
Sirius ID :
The strength of both the SIRIUS and terrestrial signals can be checked
at menu "Input Setup" – "Antenna Aiming" (vpage 35).
Presetting Radio Channels
TUNING
is pressed and (Preset Memory)
Your favorite broadcast channels can be preset so that you can
tune them in easily. Up to 56 channels can be preset.
.
1
Tune in the broadcast channel you want to preset.
2
[MEMORY]
Press
3
SHIFT
Press
channel is to be preset.
4
[SAT TU 1/2]
<PRESET>
Press
preset number (1 to 8).
5
[MEMORY]
Press
To preset other channels, repeat steps 1 to 5.
NOTE
Preset channels are erased by overwriting them.
Listening to Preset Channels
1
SHIFT
Press
2
<PRESET>
Press
desired preset channel (1 to 8).
.
to select the block (A to G) in which the
[CHANNEL +/–]
or to select the
again to complete the setting.
to select the memory block (A to G).
[CHANNEL +/–]
or to select the
Searching Categories
1
[o p]
Press .
SR001 Hits 1
Channel category
CAT : Pops
2
[o p]
Use to select the category, then use
select the desired channel.
• "UPDATING" is displayed while the encording code is being
updated.
• "SIRIUS UPDATING" is displayed when updating SIRIUS tuner
firmware.
• Refer to "Troubleshooting" – "SIRIUS Satellite Radio" regarding other
messages (vpage 73).

Parental Lock

1
Tune to the channel you want to lock.
2
[ENTER]
Press for at least 3 seconds.
"Code: [ ]" is displayed.
3
Enter the 4-digit lock code using uio p
When you enter the correct code, the corresponding channel is
locked.
4
[ENTER]
Press .
• Channels under Parental Lock cannot be tuned in by performing
Tuning Up/Down or by category search.
• Channels stored in preset memory can be tuned in by the preset
channel select operation, even if Parental Lock is applied.
• When a channel to which Parental Lock is applied is being played,
Parental Lock for that channel is cancelled by performing Step2.
• See "Edit Lock Cord" (vpage 35) for the method of changing
Parental Lock Cord.
• You can also set "Parental Lock" from the menu (vpage 35).
ENGLISH
[ui]
to
.
0