Auto Setup; Start Menu - Denon AVR-889 Owner's Manual

ENGLISH

Auto Setup

Optimize settings for speakers in use.
a Start Menu
The settings found at this stage are applied automatically.
GAuto setup fl owH
Step 1: Speaker Detection
Step 2: Measurement
Step 3: Calculation
Step 4: Check
Step 5: Store
NOTE
• Loud test sounds may be played during Audyssey MultEQ automatic
speaker setup. This is part of normal operation. If there is background
noise in room, these test signals will increase in volume.
• Do not stand between the speakers and setup microphone or allow
obstacles in the path while the measurements are being made. This
will cause inaccurate readings.
• Make the room as quiet as possible. Background noise can disrupt
the room measurements. Close windows, silence cell phones,
televisions, radios, air conditioners, fl uorescent lights, home
appliances, light dimmers, or other devices as measurements may
be affected by these sounds.
Cell phones should be placed away from all audio electronics during
the measurement process as Radio Frequency Interference (RFI)
may cause measurement disruptions (even if the cell phone is not in
use).
MASTER VOLUME
• Operating during the measurements will cancel
the measurements.

About the Auto Setup
The Audyssey MultEQ auto setup function detects the presence of
each speaker and automatically calculates the speaker size, channel
level, distance, and optimal crossover frequency setting. Audyssey
MultEQ corrects acoustical distortions within the listening area.
Before starting, connect and position all of your speakers.
Once started, MultEQ will play a series of test tones through each
speaker.
b Before starting Auto Setup (vq)
If adjustment to the environment is necessary, set the following items
before proceeding.
n Front Speaker
The front speaker to be measured can be selected ahead of time
here.
[Selectable items]
A
: Output test tone from front speakers A.
B
: Output test tone from front speakers B.
A+B
: Output test tone from front speakers A and B.
n Amp Assign
Advanced setting : changes power amplifi er assignment.
You can use the surround back speaker for multi-zone, and for front
channel bi-amp use. (Default : ZONE2)
For details, refer to "Amp Assign" (vpage 29).
Step 1 : Speaker Detection
F Menu screen F
q

1-1.Start Menu

Audyssey MultEQ
Auto Setup
Step1:Speaker Detection
Please place microphone
Step1:Speaker Detection
at ear height at
main listening position.
Front Sp. A
Amp Assign
Start
Cancel
The speaker connection and polarity are detected at the fi rst
measurement position (main listening position). The following
attributes are also determined at this time: "Speaker Size", "Speaker
Distance", "Channel Level", "Crossover Frequency".
q Select "Start 0", then press o .
• Starts measuring the main listening position.
w Select "Next 0", then press o .
n To cancel Auto Setup
Press ui to select "Cancel 0", then press
•If an error message appears during the measurements, check "Error
Messages", take the advised action, then start the measurements
again (vpage 23).
• If the result differs from the actual connection status or an error
message appears, use i to on-screen display "Retry 0" and then
press to repeat the measurement.
o
• If the result still differs from the actual connection status after
re-measurement or the error message still appears, it is possible
that the speakers are not connected properly. Turn the AVR-889
off, check the speaker connections and repeat the measurement
process from the beginning.
NOTE
Do not change the speaker connections or subwoofer volume after
"Step 1".
w
Audyssey MultEQ
Front Sp.
Yes
Center Sp.
Yes
Subwoofer
Yes
Surround Sp.
Yes
S.Back Sp.
Yes
2spkrs
Next
Retry
o .