Denon AVR-1612 Owner's Manual page 57

Tone
Adjust the tonal quality of the sound.
Setting items
Tone Control ON : Allow tone adjustment (bass, treble).
Set the tone control function OFF : Playback without tone adjustment.
to ON and OFF.
"Tone Control" can be set when "Dynamic EQ ® "
set to "OFF".
NOTE
The tone cannot be adjusted in the "DIRECT" mode.
Bass –6dB – +6dB
Adjust low frequency range
"Bass" can be set when "Tone Control" is set to "ON".
(bass).
Treble –6dB – +6dB
Adjust high frequency range
"Treble" can be set when "Tone Control" is set to "ON".
(treble).
BD
Setting details
(vpage 55) is
Audyssey Settings
Set Audyssey MultEQ ® , Audyssey Dynamic EQ ® and Audyssey Dynamic Volume ® . These can be selected
after Audyssey ® Auto Setup has been performed. For additional information on Audyssey technology,
please see page 89.
NOTE
• If you have not performed Auto Setup, or if you change the speaker settings after performing Auto Setup,
you may not be able to select Dynamic EQ ® /Dynamic Volume ® .
In this case, either perform Audyssey ® Auto Setup over again or perform "Restore" (vpage 17) to
return to the settings after Audyssey ® Auto Setup was run.
• When HD Audio for which the sampling frequency exceeds 96 kHz is played back, the "Audyssey
Settings" cannot be set.
Setting items
MultEQ ®
Audyssey : Optimize the frequency response of all speakers.
MultEQ ® corrects both time
Audyssey Byp.L/R : Optimize frequency response of speakers except
and frequency response front L and R speakers.
problems in the listening Audyssey Flat : Optimize frequency response of all speakers to flat
area based on Audyssey ®
response.
Auto Setup calibration. We Manual : Apply frequency response set with "Manual EQ" (vpage 55).
OFF : Turn "MultEQ ® " equalizer off.
recommend "Audyssey".
MultEQ ® is the prerequisite
function for Dynamic EQ ®
• "Audyssey", "Audyssey Byp. L/R" and "Audyssey Flat" can be selected
and Dynamic Volume ® .
after Audyssey ® Auto Setup has been performed. "Audyssey" is
automatically selected after performing Audyssey ® Auto Setup. When
"Audyssey", "Audyssey Byp. L/R" or "Audyssey Flat" is selected,
illuminates.
• After running Audyssey ® Auto Setup, if the Speaker Configuration,
Distance, Channel Level, and Crossover Frequency have changed
without increasing the number of speakers measured, only
illuminates.
NOTE
• "MultEQ ® " and "Manual" cannot be selected when "EQ Customize" is
set to "Not Used" (vpage 63).
• When using headphones, "MultEQ ® " is automatically set to "OFF".
"MultEQ ® ", "Dynamic EQ ® " and "Dynamic Volume ® " settings are stored for each input source.
54
Audio Adjust
Default settings are underlined.
Setting details
vSee overleaf