Denon AVR-1612 Owner's Manual page 44

5
Use o p to select the
configuration of the connected
speakers.
NORMAL Set for connecting the surround back speakers to
the SURR.BACK/FRONT HEIGHT connector in PRE
OUT.
F.HEIGHT Set for connecting the front height speakers to the
SURR.BACK/FRONT HEIGHT connector in PRE
OUT.
6
RETURN B
Press to exit the "Pre Assign" setting.
BD
7
Set up "Channel Select"
Use ui to select "Channel Select", and then press
ENTER
.
Audyssey Auto Setup
Preparation
Set the following items
if necessary.
Pre Assign
Channel Select
Auto Setup Start
[ENTER] Enter [RETURN]
Channel Select
Surround Back Measure (2 sp)
Subwoofer Measure
[RETURN] Return
8
Use ui to select a channel.
Surround
Select the number of surround back speakers to be
Back
used. In this case, go to step 9.
• "Surround Back" can be set when "Pre Assign" is
set to "NORMAL".
Subwoofer Select for no subwoofer to be used. In this case, go
to step 10.
41
9
Use o p to set whether or not a surround back
channel is measured.
Measure
Set for measuring two surround back speakers.
(2 sp)
Measure
MultEQ
Set for measuring a surround back speaker.
(1 sp)
Set for no measuring of a surround back speaker.
Skip
10
Use o p to set whether or not a subwoofer channel
is measured.
Measure Set for measuring a subwoofer.
Cancel
Skip
Set for no measuring of a subwoofer.
11
Press RETURN B
Proceed to page 13
NOTE
After performing Audyssey ® Auto Setup, do not change the speaker
connections or subwoofer volume. In event of a change, perform
Audyssey ® Auto Setup again.
Set up speakers
.
STEP1 Preparation step 6.