Enabling Snmp Traps; Figure 73. Snmp Trap Configuration; Table 54. Snmp Traps - D-Link DWS-3024 User Manual

Enabling SNMP Traps

If you use Simple Network Management Protocol (SNMP) to manage the D-Link Unified
Switch, you can configure the SNMP agent on the switch to send traps to the SNMP manager
on your network from the Administration > Advanced Configuration > Global > SNMP
Traps tab.

Figure 73. SNMP Trap Configuration

The AP does not send out any traps. The switch generates all SNMP traps based on its own
events and events it learns about through updates from the APs it manages.
Table 54 describes the events that generate SNMP traps. All traps are disabled by default.

Table 54. SNMP Traps

Field
AP Failure Traps
AP State Change
Traps
Client Failure
Traps
Client State
Change Traps
Description
If you enable this field, the SNMP agent sends a trap if an AP fails to
associate or authenticate with the switch.
If you enable this field, the SNMP agent sends a trap for one of the following
reasons:
• Managed AP Discovered
• Managed AP Failed
• Managed AP Unknown Protocol Discovered
• Managed AP Load Balancing Utilization Exceeded
If you enable this field, the SNMP agent sends a trap if a wireless client fails
to associate or authenticate with an AP that is managed by the switch.
If you enable this field, the SNMP agent sends a trap for one of the following
reasons associated with the wireless client:
• Client Association Detected
• Client Disassociation Detected
• Client Roam Detected
8 Configuring Advanced Settings
Enabling SNMP Traps 161