L2Tp - D-Link EBR-2310 User Manual

Section 3 - Configuration
Choose L2TP (Layer 2 Tunneling Protocol) if your ISP uses a L2TP connection.Your ISP will provide you with a username
and password. This option is typically used for DSL services.

L2TP:

Select Dynamic (most common) or Static. Select Static
if your ISP assigned you the IP address, subnet mask,
gateway, and DNS server addresses.
IP Address:
Enter the IP address (Static L2TP only).
Subnet Mask:
Enter the Primary and Secondary DNS Server Addresses
(Static L2TP only).
Gateway:
Enter the Gateway IP Address provided by your ISP.
DNS:
The DNS server information will be supplied by your ISP
(Internet Service Provider.)
Server IP:
Enter the Server IP provided by your ISP (optional).
Enter your L2TP account name.
L2TP Account:
Enter your L2TP password and then retype the password
L2TP Password:
in the next box.
Maximum Idle
Enter a maximum idle time during which the Internet connection is maintained during inactivity. To disable this feature, enable
Time:
Auto-reconnect.
MTU:
Maximum Transmission Unit - you may need to change the MTU for optimal performance with your specific ISP. 1492 is the
default MTU.
Connect Mode:
Select either Always-on, Manual, or Connect-on demand.
D-Link EBR-2310 User Manual
Internet Setup
L2TP
21