Appendix E: Bandwidth Management; Overview; Creation Of New Services - Cisco RV016 User Manual

Appendix E
Appendix E:
Bandwidth Management

Overview

This appendix explains how to ensure Quality of Service
(QoS) on Vonage Voice over Internet Protocol (VoIP)
phone service. This example uses Vonage; however, similar
instructions will apply to other VoIP services.

Creation of New Services

Create two new services,
Vonage 2.
1. Visit Vonage's website at http://www.vonage.com.
Find out the ports used for Vonage VoIP service.
2. Access the Router's web-based utility. (Refer to
"Chapter 4: Advanced Configuration" for details.)
System Management tab.
3. Click the
Bandwidth Management screen, click Service
4. On the
Management.
System Management > Bandwidth Management
5. On the Service Management screen, enter a name, such
as Vonage VoIP, in the Service Name field.
10/100 16-Port VPN Router
Vonage VoIP and
Bandwidth Management
Add Vonage VoIP Service
6. From the Protocol drop-down menu, select the
protocol the VoIP service uses. For example, some VoIP
devices use UDP.
7. Enter its SIP port range in the
example, you can set the Port Range to 5060 to 5070
to make sure that all active ports are covered.
Add to List.
8. Click
9. Add a second service. Enter a name, such as Vonage 2,
in the Service Name field.
Add Vonage 2 Service
Protocol drop-down menu, select UDP.
10. From the
11. Enter the RTP port range in the
are required for both incoming and outgoing traffic.
For example, you can set the Port Range to 10000 to
25000 to make sure that all active ports are covered.
Add to List.
12. Click
Apply to save your changes.
13. Click
Port Range fields. For
Port Range fields. These
76