TRENDnet TEG-S2600I User Manual page 42

3. You can setting new value for STP parameter, then click set Apply button to modify
Parameter Description
Priority You can change priority value, A value used to identify the root bridge.
The bridge with lowest value has the highest priority and is selected as
the root. Enter a number 1 through 65535.
Max Age You can change Max Age value, The number of second bridge waits
without receiving Spanning-Tree Protocol configuration messages
before attempting a reconfiguration. Enter a number 6 through 40.
Hello Time You can change Hello time value, the number of seconds among the
transmission of Spanning-Tree Protocol configuration messages. Enter a
number 1 through 10.
You can change forward delay time, The number of seconds a port waits
Forward
Delay time before changing from its Spanning-Tree Protocol learning and listening
states to the forwarding state. Enter a number 4 through 30.
4. The following parameter can be configured on each port , click set Apply button to modify
Parameter Description
You can make it more or less likely to become the root port, the rage is
Port Priority
0-255,default setting is 128
The lowest number has the highest priority.
Specifies the path cost of the port that switch uses to determine which port
Path Cost
are the forwarding ports
the lowest number is forwarding ports, the rage is 1-65535 and default
value base on IEEE802.1D
10Mb/s = 50-600 100Mb/s = 10-60 1000Mb/s = 3-10
- 42 -