875Ht Rear Panel Input/Output Connections Contd; Ratings Label; Power Inlet; Power-Up Connector - Bryston C Series 875HT Owner's Manual

BANANA PLUGS offer a quick disconnect option. Before inserting a banana plug into the binding post be sure
P
to tighten the post nut to avoid rattling and to provide full insertion of the banana plug. Gold plated locking
banana plugs are available from Bryston.
SPADE LUGS provide high contact area and secure fastening. Lugs should be gold plated. See diagram for
P
details. Post diameter is 5/16' ( 8mm ),lug width 5/8" (16 mm). Gold plated spade lugs are available from
Bryston.
STRIPPED BARE wire up to 3 gauge can be inserted through the hole in the binding post and held in place by
P
tightening the post knob. Additional tightening pressure can be achieved using the wrench provided in the slots of
the knob. Do not over tighten or the binding post may become damaged. Note that copper wire is malleable and
may require further tightening after the initial installation.
7 7

RATINGS LABEL

Contains the exact model name, the electrical ratings for that particular model, as well as the serial number and date
of manufacture date code (yyww)
8 8

POWER INLET:

Primary or mains power cord input connector (IEC 320 inlet). Connect the supplied power cord to this connector only
after checking the unit label and verifying that the amplifier is set for your local power requirements for A/C voltage
and line frequency.
9 9

POWER-UP CONNECTOR:

When an external 12v control signal is applied between the 2 'IN' pins on the connector, the amplifier will power up.
When the 875 has powered up the incoming 12v is handed to the 'OUT' terminals to turn on other equipment. This
circuit draws 2 ma to turn the 875 on.
875HT -
EIGHT CHANNEL POWER AMPLIFIER
4