Table of Contents
Advertisement
Advertisement
Table of Contents
Related Manuals for Bryston 3BSST2
Summary of Contents for Bryston 3BSST2
- Page 1 OWNER’S MANUAL...
- Page 2 Bryston authorized dealer to qualify for warranty service. The warranty is transferable from the original owner to a subsequent owner as long as a copy of the bill-of-sale from the original authorized Bryston dealer accompanies the re-sale. The copy of the bill of sale to any subsequent owner need ONLY include the Name of the Bryston Authorized Dealer and the Model and Serial number of the Bryston product The warranty will only be honored in the country of the original purchase unless otherwise pre-authorized by Bryston.
-
Page 3: Table Of Contents
TABLE of CONTENTS Safety Instructions, Warranty and Contact Information ...Opposite General Information ..............Page 1 Introduction Description Description Shipping & Packing Materials Ventilation Wiring the Amplifier A/C Power Power Conditioners Front Panel ................Page 2 Power Switch LED Indicators Rear Panel & Inputs/Outputs ............Page 3 Input Select Switch Balanced Input Connector Single-ended Input Connector... -
Page 4: General Information
Speaker wires should be as short as practical. Use quality wire, and if runs are more than 3 meters use at least 12 gage wire. The speaker binding posts will accept wire up to 3 gage in size. Bryston will custom build cables for your application. -
Page 5: Front Panel
FRONT PANEL . POWER SWITCH The front panel label is a push-on/push-off type push-button power switch used to apply or remove a/c line power to the SoftStart circuitry. Note that the rear circuit breaker must be on for the amplifier to power-up. 2. -
Page 6: Rear Panel & Inputs/Outputs
Post diameter is 5/16" (8mm ), lug width 5/8” (16 mm). Gold plated spade lugs are available from Bryston. Stripped bare wire up to 3 gage can be inserted through the hole in the binding post and held in place by tightening the post knob. -
Page 7: Circuit Breaker
22 to 18 gage between the source device and the SST amplifier. The appropriate mating connector (Bryston part number: 110A-11104 ) is supplied with each amplifier. REMOTE POWER TURN-ON Set the External Turn-On switch to “External”. The ampli-... -
Page 8: Bridged Mode
BRIDGED MODE "Bridged mode” refers to the combining or “bridging” of two amplifier channels in series to form a single amplifier channel. The primary reason for doing this is to achieve a single amplifier channel with much greater output power. When two 3B channels or two 4B channels are bridged the combined single channel will output up to 2 times the voltage and therefore, theoretically, 4 times the power of a single non-bridged channel. -
Page 9: Technical Specifications
SST 2 SST 2 TECHNICAL SPECIFICATIONS Power Output Power Output 150 watts per channel into 8 ohms 300 watts per channel into 8 ohms 250 watts per channel into 4 ohms 500 watts per channel into 4 ohms Gain: Gain: High: 29dB = 28.28V/V 29dB position = 28.28V/V Low: 23dB = 14.14V/V... - Page 12 300006-3 BRYSTON LTD., 677 NEAL DRIVE, P.O. BOX 2170, PETERBOROUGH, ONTARIO CANADA K9J 7Y4 2011-07-20...