Scanning Difficulties; Software Difficulties - Brother MFC-9440CN User Manual

Printing difficulties (continued)
Difficulties
The machine prints unexpectedly
or it prints garbage.
The machine prints the first couple
of pages correctly, then some
pages have text missing.
The headers or footers appear
when the document displays on the
screen but they do not show up
when it is printed.
The machine does not print on both
sides of the paper even though the
printer driver setting is Duplex.
(MFC-9450CDN only)
The machine is not printing or has
stopped printing and the machine's
Data LED turns on.

Scanning difficulties

Difficulties
TWAIN errors appear while
scanning.
Network scanning does not work.

Software difficulties

Difficulties
Cannot install software or print.
Cannot perform '2 in 1' or '4 in 1'
printing.
The machine does not print from
Adobe Illustrator.
Suggestions
Pull out the paper tray and wait until the machine stops printing. Then turn off
the machine's power switch and disconnect from the power for several
minutes. (The machine can be turned off for up to 4 days without losing faxes
stored in the memory.)
Check the settings in your application to make sure it is set up to work with
your machine.
Check the settings in your application to make sure that it is set up to work with
your machine.
Your computer is not recognizing the machine
sure that you connected the interface cable correctly. (See the Quick Setup
Guide.)
There is an unprintable area on the top and bottom of the page. Adjust the top and
bottom margins in your document to allow for this.
Check the paper size setting in the printer driver. You need to select Letter, Legal
or Folio.
Press Job Cancel. As the machine cancels the job and clears it from the memory
it may produce an incomplete printout.
Suggestions
Make sure that the Brother TWAIN driver is chosen as the primary source. In
PaperPort™ 11SE, click File, Scan or Get Photo and choose the Brother
TWAIN driver.
See Network difficulties on page 112.
Suggestions
Run the Repair MFL-Pro Suite program on the CD
and reinstall the software.
Check that the paper size setting in the application and in the printer driver are the
same.
Try to reduce the print resolution. (See Advanced tab in the Software User's Guide
on the CD-ROM.)
Troubleshooting and routine maintenance
'
s input buffer's full signal. Make
-
ROM. This program will repair
C
111