Brother MFC-9440CN User Manual page 146

Error Message Cause
You tried to access a One-Touch
Not Registered
or Speed Dial number that is not
programmed.
The machine's memory is full.
Out of Memory
Print Unable XX The machine has a mechanical
problem.
Protected Device The protect switch of the USB
flash memory drive is on.
Registration failed.
Registration
130
Action
-
Set up the One Touch or Speed Dial number.
(See Storing one-touch dial numbers on
page 56 and Storing speed-dial numbers on
page 57.)
Fax sending or copy operation in progress
Do one of the following:
Press Black Start or Color Start to send or
copy the scanned pages.
Press Stop/Exit and wait until the other
operations in progress finish, and then try
again.
Clear the data from the memory. (See Out of
memory message on page 40 or page 79.)
Print operation in process
Do one of the following:
Reduce print resolution. (See Advanced tab in
the Software User's Guide on the CD-ROM.)
Clear the faxes from the memory. (See Out
of memory message on page 79.)
'
Turn off the machine s power switch and then
turn it on again. If the error message continues
leave the machine for several minutes and then
try to print, copy or scan again. The machine can
be turned off for up to 4 days without losing faxes
stored in the memory. (See Checking if the
machine has faxes in its memory on page 132.)
Turn off the protect switch of the USB flash
memory drive.
Press Black Start or Color Start and try again.
Do one of the following:
Try Manual Registration, Menu, 4, 7. (See
Manual Registration on the Software User's
Guide on the CD-ROM.)
Put in a new belt unit. (See Replacing the
belt unit on page 178.)
Put in a new drum unit. (See Replacing the
drum unit on page 171.)
Replace the empty toner cartridge with a
new one. (See Replacing a toner cartridge
on page 166.)
Turn off the machine's power switch. Wait a
few seconds, then turn it on again.
If the problem continues, call Brother
Customer Service.