Figure 4 - Bose Wave music system Supplementary Manual

English Deutsch
Mounting the bracket under a cabinet

Figure 4

Marking drill holes for
under-cabinet mounting
Figure 5
Under-cabinet attachment
steps
Español Français Italiano
In an under-cabinet mounting, the front of your Wave
(28.5 cm) from the rear of the mounting assembly. On either side, your Wave
measures 7¼ inches (18.4 cm) from the center of the platform.
Before drilling any holes:
1. Remove the assembly screws and Caution card from the mounting assembly. !
Save one of the screws for use in assembling the bracket.
2. Position the mounting assembly at the angle you want under the cabinet.
3. Mark the three drill holes with a pencil (Figure 4).
WARNING: Do NOT use the mounting assembly as a template while drilling.
Use the proper mounting hardware and drill hole size indicated below:
Mounting surface
Particle board or wood
cabinet bottom!
½" to 1" thick
CAUTION: If your
cabinet is not as strong as
specified above, mounting
there can damage your
shelf or cause the bracket
to fall. Use a different
surface for mounting the
bracket.
Drill the three holes and attach the bracket as shown (Figure 5).!
Do not use a screw gun to tighten the cabinet screws.
¼" ¼" ¼"
6.5 mm 6.5 mm 6.5 mm
Nederlands Thai
U -
NDER CABINET INSTALLATION
system measures 11¼ inches !
®
CAUTION: Be sure to use all three
screws in the mounting assembly holes.
Supplied hardware to use
Cabinet screws and capnuts
¼" ¼"
- 20 x 1
Cabinet screws
Bracket
Cap nuts
Korean S. Chin Arabic
system !
®
Drill bit type Hole size
¼" (6.5 mm)
Twist bit
¼"
(6.5 mm)
5