Bosch VG4-161-CC0 Installation Manual page 90

90 en | Cable and Wire Standards
The following figure illustrates the connections necessary to transmit video and control over a
UTP cable.
Figure 5.1 Video and Control over UTP
1
2
Ethernet
AutoDome Ethernet models are connected to a 10/100 Base-T network either directly or via a
hub. Both video and control are transmitted over a standard TCP/IP network using the built-in
web server.
Cable Type
Maximum Distance
Bandwidth
Terminal Connector
WARNING!
Do not connect the RJ45 connector unless using UTP video or Ethernet.
Multi-mode Fiber Optic
Fiber Optic models transmit both video and Biphase control over an analog singlemode or
multimode fiber. A full or half duplex, multimode IP media converter fiber optic module is also
available.
Multimode
Fiber Type
Maximum Distance
Minimum Bandwidth
Requirement
Terminal Connector
Singlemode
Fiber Type
Maximum Distance
Minimum Bandwidth
Requirement
Terminal Connector
F.01U.216.010 | 8.0 | 2011.02
+
-
Head End Video 3 Pins
Coax 4 AutoDome
UTP CAT-5
100 m (328 ft)
10/100 Base-T
RJ45
50/125 µm, 62.5/125 µm, low loss multimode glass fiber
4 km (2.5 miles)
20 MHz (Video - 850 nm / Control - 1300 nm)
Bosch LTC 4629 Fiber Receiver at controller end of system
ST
9/125 µm, low loss single glass fiber
69 km (43 miles)
20 MHz (Video - 1310 nm /Control - 1550 nm)
Single mode fiber receiver at controller end of system
ST
Installation Manual
VG4 Modular Camera Series
1(+) & 2(-)
RJ45
Bosch Security Systems, Inc.