Remote Control Effective Range - BenQ W1000 User Manual

17. S-VIDEO
Displays the S-VIDEO source selection.
See "Switching input signal" on page 28
for details.
18. PC
Displays the PC source selection. See
"Switching input signal" on page 28
19. HDMI 2
Displays the HDMI 2 source selection.
See "Switching input signal" on page 28
for details.
20. Right cursor/Panel Key Lock (
: Navigates and changes settings in the
OSD. See
25 for details.
: Activates panel key lock. See
control keys" on page 39
21. Down cursor/Keystone (
: Navigates and changes settings in the
OSD. See
25 for details.
: Manually corrects distorted images
resulting from an angled projection.
See "Correcting keystone" on page
30 for details.

Remote control effective range

Infra-Red (IR) remote control sensor is located on the
front and the rear of the projector. The remote control
must be held at an angle within 30 degrees perpendicular
to the projector's IR remote control sensor to function
correctly. The distance between the remote control and
the sensor should not exceed 7 meters (~ 23 feet).
Make sure that there are no obstacles between the remote
control and the IR sensor on the projector that might
obstruct the infra-red beam.
12 Introduction
for details.
/
"Using the menus" on page
"Locking
for details.
/ )
"Using the menus" on page
22. ASPECT
Select the display aspect ratios. See
"Selecting the aspect ratio" on page 31
for details.
23. CONTRAST
Displays the CONTRAST setting bar. See
"Adjusting Contrast" on page 34
24. SHARP
Displays the SHARPNESS setting bar. See
"Adjusting Sharpness" on page 34
25. TINT
)
Displays the TINT setting bar. See
"Adjusting Tint" on page 34
26. COLOR
Displays the COLOR setting bar. See
"Selecting a Color Temperature" on page
35 for details.
27. BLANK
Hides the screen picture. See
image" on page 38
28. FREEZE
Freeze/unfreezes the on-screen picture. See
"Freezing the image" on page 39
29. TEST
Displays the test pattern.
for details.
for details.
for details.
"Hiding the
for details.
for details.