EDVR Installation and Operation Guide
Sequence Settings Menu
This page enables you to select from ten modes to configure the sequence of displays for the main monitor, and
a single mode for the call monitor.
The dwell time for each of the displays can be set between 0 (no - show) and 99 seconds when you press the
SEQ (Sequence) button (default = 3 sec.). To set dwell time for each camera, first select a display mode from the
Sequence Settings menu, then press ENTER. Select a camera, and use the shuttle ring to change the dwell
value for a camera. When you select a camera, you will see that camera's video in the lower right corner of the
display. Press Return or MENU to return to the Sequence Settings menu.
Main Menu
1 Quick Settings
2 Display Options
3 Sequence Settings
4 Picture Adjust
5 Operation Log
6 Advanced Settings
7 Default Settings
8 Password Settings
9 Exit Menu
enter: select
/: item
Call + ◄/►English Francais Espanol
Italiano Deutsch
Note
In the Sequence Settings menu, items 5 through 7 are for the 9CH and 16CH EDVR versions, and items 8
through 10 are for the 16CH EDVR version only.
1.
1- Channel Display
Set a full-screen sequence.
2.
2- Channel Display
Set full-screen mode with an inset, either of which can be in the sequence mode.
3.
3- Channel Display
Set a triple window mode, with any one of them in sequence status.
4.
3- Channel Display
Set a different arrangement of three windows, with any one of them being sequential.
44
Sequence Settings
Main Monitor
1
1-Channel Display
2
2-Channel Display
3
3-Channel Display
4
3-Channel Display
>
5
4-Channel Display
6
6-Channel Display
7
8-Channel Display
8
9-Channel Display
9
10-Channel Display
10
13-Channel Display
Call Monitor
11 Full Screen Display
Return
menu: exit
enter: select
/ : item
Enter
Enter
Enter
Enter
Enter
Enter
Enter
Enter
Enter
Enter
Enter
EDVR