American Dynamics EDVR Installation And Operation Manual page 47

Note
The baud rate of the PTZ cameras must be the same for all of the cameras. Set all of your cameras' uniform
baud rate in the Baud Rate entry on the RS-485 Settings page (that is, on this page).
7. Use the Down button to select Return, and press
ENTER.
8. Press Return again, and press ENTER.
9. On the Advanced Settings page, choose item 9,
Dome Settings, and press ENTER.
10. On this page you can set all of the cameras' protocol
settings. Change each setting to the camera protocol
on that channel.
11. After you set all of the channel protocols, choose
Return, and press ENTER.
12. Choose Return again, and press ENTER.
13. Choose item 9, Exit Menu, and press ENTER.
14. Choose Exit Menu with Saving and press ENTER.
15. Your menu settings are complete.
Using the EDVR Front Panel to Control the PTZ Cameras
Press the DISPLAY and ZOOM buttons simultaneously on the EDVR front panel to toggle in and out of the PTZ
MODE. While in PTZ mode, both buttons illuminate and flash. Refer to the section PTZ Operation on page 6 for
details.
When a dome camera is selected press the DISPLAY button alone to bring up the help information.
DISPLAY button
Dome Settings
CAM1
CAM2
CAM3
CAM4
CAM5
CAM6
CAM7
CAM8
CAM9
CAM10
CAM11
CAM12
CAM13
CAM14
CAM15
CAM16
Return
CAM1 AD422 1
◄►▲▼: PAN/TITL
SHUTTLE: ZOOM
MENU/ENTER: FOCUS
>
SEQ. /SEARCH: IRIS
CALL: GOTO PRESET
FREEZE: SET PRESET
DISPLAY: SHOW HINT
Basic Operations
ID Protocol
1 AD422
2 AD422 menu: exit
3 AD422 shuttle: value
/: item
1 None
1 None (for 9/16CH EDVR only)
1 None (for 9/16CH EDVR only)
1 None (for 9/16CH EDVR only)
1 None (for 9/16CH EDVR only)
1 None (for 9/16CH EDVR only)
1 None (for 16CH EDVR only)
1 None (for 16CH EDVR only)
1 None (for 16CH EDVR only)
1 None (for 16CH EDVR only)
1 None (for 16CH EDVR only)
1 None (for 16CH EDVR only)
1 None (for 16CH EDVR only)
37