11
Utilities
To Add a Test Code I.D. Prefix to All Symbologies
This selection allows you to turn on transmission of a Code I.D. before the
decoded symbology. (See the
acter code that identifies each symbology.) This action first clears all current
prefixes, then programs a Code I.D. prefix for all symbologies. This is a tempo-
rary setting that will be removed when the unit is power cycled.
Show Decoder Revision
Scan the barcode below to output the decoder revision.
Note: You may use the Show Decoder Revision option if you have firmware with
a base number of 31205480. Refer to
11-2 for information on determining the firmware revision in your unit.
Show Engine Revision
Note: You may use the Show Engine Revision option if you have firmware with
a base number of 31205480.
Scan the barcode below to output the engine revision. Your imager returns the
engine type, revision number, and status character [ACK]. For example, an
imager with a 5100 engine, version 26 would return:
ENGREVType:
Symbology
Chart, page A-1, for the single char-
Add Code I.D. Prefix to
All Symbologies (Temporary)
Show Decoder Revision
1
Revision: 26[ACK]
Show Engine Revision
Show Software Revision
on page
11 - 1