Table of Contents
Advertisement
Boot Protocol
Applies only if the S/W Update Control is enabled.
Boot Server IP Address The IP address of the TFTP server where
the configuration file is located. This entry is used only if the S/W
Update Control is enabled and your boot protocol is
you are using
bootp-tftp
Power Up is enabled, the address will be obtained from the BOOTP
server.
Boot File Name The pathname of the configuration file on your
TFTP server. If you are using D-View as your TFTP server, this is
the pathname of the
only if your boot protocol is TFTP ONLY; if you are using
BOOTP&TFTP mode, or if Use Bootp to get IP after start up is
enabled, the pathname will be obtained from the BOOTP server.
For more information about DES-2218 configuration files, consult the
appendix.
For detailed information about using the TFTP and BOOTP
servers, consult the D-View User's Guide.
Using the Console Interface
Set to either TFTP ONLY or BOOTP&TFTP.
mode, or if Send BOOTP Request on
.CFG
file on your hard disk. This entry is used
Figure 6-12. Software Update Menu
DES-2218 Ethernet Switch User's Guide
tftp only
; if
35
Advertisement
Table of Contents
