Listening To Am/Fm Radio - Onkyo TX-NR3010 Instruction Manual

Listening to AM/FM Radio

This section describes the procedure of using the
buttons on the front panel, unless otherwise specified.
Using the Tuner
With the built-in tuner you can enjoy AM and FM radio
stations. You can store your favorite stations as presets for
quick selection.
You can also change the frequency steps
1 Press TUNER to select either "AM" or "FM".
In this example, FM has been selected.
Each time you press TUNER, the radio band changes
between AM and FM.
Band Frequency
(Actual display depends on the country.)
Tuning into Radio Stations
■
Auto tuning mode
1 Press TUNING MODE so that the AUTO indicator
lights on the AV receiver's display.
2
Press TUNING q/w.
Searching stops when a station is found.
When tuned into a station, the TUNED indicator
(➔ page 83).
lights. When tuned into a stereo FM station, the FM
STEREO indicator lights as shown.
Tip
• Tuning into weak FM stereo stations
If the signal from a stereo FM station is weak, it may be
impossible to get good reception. In this case, switch to
manual tuning mode and listen to the station in mono.
■
Manual tuning mode
In manual tuning mode, FM stations will be in mono.
1 Press TUNING MODE so that the AUTO indicator
goes off on the AV receiver's display.
2
Press and hold TUNING q/w.
The frequency stops changing when you release the
button.
Press the buttons repeatedly to change the frequency
one step at a time.
TUNED
AUTO
FM STEREO
En-37
Turning On & Basic Operations
■
Tuning into stations by frequency
You can tune into AM and FM stations directly by entering
the appropriate frequency.
1 On the remote controller, press TUNER repeatedly
to select "AM" or "FM", followed by D.TUN.
(Actual display depends on the country.)
2
Within 8 seconds, use the number buttons to enter
the frequency of the radio station.
For example, to tune to 87.5 (FM), press 8, 7, 5 or 8,
7, 5, 0.
If you have entered the wrong number, you can retry
after 8 seconds.
Presetting AM/FM Stations
You can store a combination of up to 40 of your favorite
AM/FM radio stations as presets.
1
Tune into the AM/FM station that you want to store
as a preset.
See the previous section.
2 Press MEMORY.
The preset number flashes.
(Actual display depends on the country.)
3
While the preset number is flashing (about 8
seconds), use PRESET e/r to select a preset from
1 through 40.
To be continued