Listening To The Am/Fm Radio (Am: North American Models Only) - Onkyo TX-8220 Instruction Manual

> Before Start > Part Names

Listening to the AM/FM Radio (AM: North American Models only)

1
You can receive AM (North American
models) /FM radio stations on this unit with
the built-in tuner. Perform the following
procedure when the unit is on.
∫ Tuning into a Radio Station
Tuning Automatically
The unit is set to the auto-tuning mode by
default. If the signal from a radio station is
weak, perform the procedure for "Tuning
Manually" in the next section. Note that if
you tune manually, the reception for FM
broadcasts will be monaural rather than
stereo, irrespective of the sensitivity of the
reception.
1. Repeatedly press TUNER (e) on the
remote controller and select "AM" or
"FM".
2. When you press the cursor Up/Down
buttons (c) on the remote controller,
automatic tuning starts, and searching
stops when a station is found. When
tuned into a radio station, the
> Install > Playback
2
"1TUNED2" indicator on the display
lights. When tuned into a stereo FM
radio station, the "FM STEREO"
indicator lights.
Tuning Manually
If you tune manually, the reception for FM
broadcasts will be monaural rather than
stereo, irrespective of the sensitivity of the
reception.
1. Repeatedly press TUNER (e) on the
remote controller and select "AM" or
"FM".
2. After pressing SETUP (d) on the remote
controller, use the cursor Up/Down
buttons (c) to select "Mono" in "Tuner
Setting" - "Tuning Mode", and then press
ENTER to set.
Mode : Mono
3. Press SETUP (d) on the remote
controller to return to the tuning display.
4. While pressing the cursor Up/Down
buttons (c) on the remote controller,
select the desired radio station.
0 The frequency changes by 1 step
each time you press Up/Down
buttons. The frequency changes
continuously if the button is held down
and stops when the button is
released.
Tuning into Stations by Frequency
It allows you to directly enter the frequency
of the radio station you want to listen to.
1. Press TUNER (e) of the remote
controller repeatedly to select either
"AM" or "FM".
2. Press D.TUN (b) on the remote
controller twice.
3. Using the number buttons (a) on the
remote controller, enter the frequency of
the radio station within 8 seconds.
0 To enter 87.5 (FM), for example,
press 8, 7, 5 or 8, 7, 5, 0. If the
entered number is incorrect, press
D.TUN twice again and re-enter the
number.
Setup | Others
a
b
c
d
e
En 15