Onkyo TX-NR3010 Instruction Manual page 91

From the connecting block
Miniplug cable
AV receiver
Signal flow
Using a Multiroom Kit with a Cabinet
In this setup, the IR receiver picks up the infrared signals
from the remote controller and feeds them to the AV
receiver located in the cabinet via the connecting block.
Connecting
block
IR IN
Inside
Remote controller
cabinet
Signal flow
Using a Multiroom Kit with Other
Components
In this setup, an IR emitter is connected to the AV
receiver's IR OUT jack and placed in front of the other
component's remote control sensor. Infrared signals
received at the AV receiver's IR IN jack are fed through to
the other component via the IR emitter. Signals picked up
by the AV receiver's remote control sensor are not output.
IR IN
IR OUT
IR
receiver
Signal flow
The IR emitter should be connected to the AV receiver's
IR OUT jack, as shown below.
From the connecting block
Miniplug cable
Remote control sensor
AV receiver
Miniplug
IR receiver
Connecting
block
AV receiver
IR Emitter
Remote controller
Other component
Other component
Emitter
IR Emitter
Signal flow
En-91
Advanced Operations