Table of Contents
Advertisement
Hardware Description
Rear Panel
Reset
Used to restore the VDI-604 back to factory default settings.
LAN
LAN port sockets (CAT5 Ethernet RJ-45 cable). The LED
PORTS*
glows steadily when a port is connected to a hub, switch or
1-4
network-adapter-equipped computer in your local area network
(LAN.)
WAN*
WAN port socket (CAT5 Ethernet RJ-45 cable). This is where
you will connect to your high speed Internet access
Power
Connect one end of your included power adapter to the power
port and the other end into your power outlet.
*All ports (both LAN & WAN) are Auto-MDIX. All ports auto-sense cable
types to accommodate Straight-through or Cross-over cable.
Reset
To reset the system settings to factory defaults, please follow these steps:
1. Leave the device powered on, do not disconnect the power
2. Press the reset button and hold (use a paper-clip)
3. Keep the button pressed about 10 seconds
4. Release the button
The VDI-604 will then automatically reboot itself.
WAN
LAN
-9-
Reset
Power
Advertisement
Table of Contents
