Installation; Initial Setup; Reset; Sim - D-Link AC1200 User Manual

Section 2 - Installation
This section will guide you through the installation process. Placement of the router is very important. Do not place the router in an enclosed area
such as a closet, cabinet, or in an attic or garage.
Ensure that your DWR-960 is disconnected and powered off before performing the steps below.
1. Verify that your SIM/UICC card is installed and has been activated by your carrier. To install
your SIM/UICC card, follow the orientation diagram next to the slot. Push gently until it
locks into place.
Caution: Always unplug/power off the router before installing or removing the SIM/UICC card.
Never insert or remove the SIM/UICC card while the router is powered on.
2. Attach the included antennas to the back of the router, screwing them in clockwise. Arrange
them so that they point upwards.
3. Connect the power adapter to the socket on the back panel of your DWR-960. Plug the
other end of the power adapter into the wall outlet or power strip.
4. Press the power button and wait for three seconds for the device to be powered on.
a. The Power LED will light up green to indicate that power is being supplied to the router
and the router is turned on.
b. After a few moments, the LED indicators will show the status of the router's various
functions. For more information, please refer to LED Indicators on page 6.
D-Link DWR-960 User Manual

Installation

Initial Setup

1.

SIM

RESET

WPS

SIM
card
2.
3.
7