Installing And Running The Configuration Utility; Configuration Utility Modes - D-Link AirPremier DWL-1800 User Manual

3.1 Installing and Running the Configuration
Utility
The Configuration Utility is provided for installation on a 3.5" diskette.
1. Insert the provided diskette into the computer where you wish to
install the Configuration Utility.
2. Run Brzmgr mgr.exe.
3. Follow all instructions until you are informed that the Utility was
installed successfully.
4. Run the Configuration Utility from the Start menu by selecting it in
the D-Link AirPremier DWL-1800 Configuration Utility folder under
Programs.

3.2 Configuration Utility Modes

There are several D-Link AirPremier DWL-1800 Configuration Utility modes of
operation; these options are selected via the Mode menu in the configuration utility
main window (shown below). The selected mode(s) is indicated by a check mark in
the menu.
Unit configuration - This is the default mode and is used for setting
parameters as detailed in this manual.
Firmware upgrade – Used for upgrading the embedded software in
managed units; refer to Section 3.2.2 for instructions on using this
feature.
Multiple configuration – Used for setting configuration parameters for
more than one unit simultaneously; refer to Section 3.2.3 for
instructions on using this feature.
19