Table of Contents
Advertisement
Trap quick view - When set to this mode, the PC (if set as described in
Section 3.2.1.3.3) switches automatically to the Trap Monitor tab when
Unit Configuration mode is selected.
3.2.1 Unit Configuration Mode
The Control Window Section
In this section, you can:
Discover the units that are connected to the network.
View DWL-1800 units that have been discovered by their IP address.
Select the units you wish to manage.
Locate units behind a router that cannot be detected by the autodiscovery
feature
Assign unit IP addresses based on unit MAC addresses.
Set the SNMP Community string.
If there are many units in the managed network, you can enlarge the list box by
clicking on the horizontal line above the list; click again to toggle back the default
display state. The list box also displays the Location of each unit, as set in the
Station Status dialog box (see Section 3.2.1.3.1).
The Tabs Section
This section consists of several tabs, each containing parameters required for the
management of the selected unit; the number of tabs displayed varies between the
type of managed unit. The different tabs are described i n the following sections.
When you switch between the tabs, the unit selection section with the selected unit
address remains displayed.
20
Advertisement
Table of Contents
