Table of Contents
Advertisement
2.6.2 Verifying Correct Operation of the Outdoor Unit
To verify proper operation, check the LED indicators located on the bottom panel of
the outdoor unit.
Name
Description
WLAN
Wireless Link
Indicator
DC Power Self Test and Power
indication
ETH
Ethernet activity/
connectivity indication
RSSI
BAR
What to do if the Self Test fails
If the Self-Test failed (DC Power LED light remains red), try the following:
Reset unit (Disconnect/reconnect the power).
Check the Indoor-to-Outdoor cable.
Reset to factory defaults (see page 42).
Contact technical support.
Functionality
Blinking Green – Data received or
transmitted on the wireless link. Blinking
rate is slower when there is less wireless
traffic.
Green – Power is available and self test
passed.
Red – Self test failed. Firmware did not
load successfully.
OFF –Ethernet connectivity is OK.
No traffic activity detected on the port.
Blinking Green –Ethernet connectivity is
OK, with traffic on the port.
Red – No Ethernet connectivity. When
this state occurs, check the Ethernet cable
and Indoor-to-Outdoor cable connections.
DWL-1800R: Received Signal Strength
Indication
DWL-1800B: Number of associated
RB-DWL-1800R units
Table 2: Outdoor Unit LEDs
17
Advertisement
Table of Contents
