Troubleshooting (Faq) - Yamaha LS9-16 Installation Manual

When controlling the LS9 from your computer via Ethernet, the LS9 does not operate correctly.
• Is the Ethernet cable connected correctly?
Refer to the "Connection of computer and the LS9" section.
• Is the DME-N Network Driver set up appropriately?
Refer to the "Setup" section.
• Did you enter an appropriate IP address of the LS9?
Set the IP address of the LS9 in the MISC SETUP screen of the LS9.
If you are connecting the LS9 to your computer in a one-to-one connection, we recommend that you make the following initial
settings.
IP address
Gateway address
Subnet mask
However, it must not conflict with the IP address of any other device on the network.
For details on settings when connecting to a LAN, refer to the LS9 Editor installation guide.
• Is the computer network setup appropriately?
Confirm the network setup by following the procedures in the
If you are connecting the LS9 to your computer in a one-to-one connection, we recommend that you make the following
settings.
IP address
Subnet mask
Default gateway
However, it must not conflict with the IP address of any other device on the network.
For details on settings when connecting to a LAN, refer to the LS9 Editor installation guide.
• Are the settings of the LS9 and peripheral network devices (including switching hubs) appropriate?
Refer to the relevant owner's manuals for the LS9 and peripheral network devices (including switching hubs) for details.
• Have you selected an appropriate ports in the LS9 Editor and Studio Manager?
Select the LS9 as the input/output port settings of LS9 Editor and Studio Manager.
• Are you using the latest DME-N Network Driver?
The latest driver can be downloaded from the Yamaha website
• Are the settings of your security software appropriate?
If using Windows firewall:
For Windows XP
→
Click [Start] [Control Panel]
For Windows Vista
→
Click [Start] [Control Panel]
incoming connections] checkbox.
For Windows 7
→
Click [Start] [Control Panel]
permitted at [Inbound Rules] and [Monitoring]
If using other security software:
Either set the security software to allow use of TCP port 12300 on the network card being used by the DME-N Network
Driver, or disable the security software.
DME-N Network Driver Installation Guide for LS9

Troubleshooting (FAQ)

192.168.0.128
192.168.0.1
255.255.255.0
192.168.0.3
255.255.255.0
192.168.0.1
→ →
[Windows Firewall] [General] tab. Remove the [Don't allow exceptions] checkbox.
→ →
[Windows Firewall] [Change settings]
→
[Windows Firewall]. Confirm the communication with the DME-N Network Driver is
→
[Firewall].
"TCP/IP Settings" section.
http://www.yamahaproaudio.com/
→
[General] tab. Remove the [Block all
U.R.G., Pro Audio & Digital Musical Instrument Division, Yamaha Corporation
© 2006 Yamaha Corporation
12
C0