Yamaha RX-V2065BL Owner's Manual page 84

Troubleshooting
iTunes Tagging (U.S.A. model only)
Problem
Tag data cannot be
transferred to your
iPod when it is station
in the Yamaha iPod
universal dock (YDS-
10).
Status message
Insufficient Data
Tag Already Stored
Tag Storage full
iPod full
Tags cannot be stored
Transferring Failed
Storing Tag
Transferring
Tag(s)Sent
XM Satellite Radio (U.S.A. model only)
If an operation takes longer than usual or an error occurs, one of the following messages may appear on the GUI screen.
In this case, read the cause and follow the corresponding remedies.
Status message
CHECK XM TUNER
CHECK ANTENNA
LOADING XM
80
En
Cause
"YDS-10" does not support tag file
transfer.
Cause
Tag data is not saved because of invalid
data.
Tag data for the same content has been
already saved.
Tag data cannot be stored because the
internal memory of this unit is full.
Tag data cannot be stored on your iPod
because the HDD space of your iPod is
full.
Tag data cannot be transferred to your
iPod.
Tag data is being stored in the internal
memory of this unit.
Tag data is being transferred to your iPod.
Tag data has been transferred to your
iPod.
Cause
The XM Mini-Tuner is not installed in the
XM Mini-Tuner Home Dock or the XM
Mini-Tuner Home Dock is not connected
to this unit.
The XM antenna is not connected to the
XM Mini-Tuner Home Dock or the XM
antenna cable has become damaged.
The XM Mini-Tuner is acquiring audio or
program information from the XM
satellite signal. This message can also
occur in weak XM signal conditions. Note
that this unit may not respond to some
operations while this message is
displayed.
Remedy
Use "YDS-11" to transfer tag data from this unit to
your iPod.
Remedy
The selected HR Radio program (or song being
played) does not support the iTunes Tagging feature.
Station your iPod in the Yamaha iPod universal dock
(YDS-11) connected to the DOCK terminal of this
unit.
Delete unnecessary data from your iPod to make
room and try again.
Check if the iPod is stationed in the Yamaha iPod
universal dock (YDS-11) properly.
Remedy
Confirm the XM Mini-Tuner is fully seated in the
dock and check the XM Mini-Tuner Home Dock
cable is connected to this unit.
Check that the XM antenna is securely connected to
the XM Mini-Tuner Home Dock and check the
antenna cable for damage. Replace the XM antenna if
the cable is damaged.
This message should disappear in a few seconds in
good signal conditions. If you see this message often,
reposition the XM antenna to get better signal
reception. Use the "Antenna" information on the front
panel display or XM information on the GUI screen
to check the antenna reception level.
See
page
—
See
page
—
—
—
—
See
page
35
35
38