Yamaha RX-V2065BL Owner's Manual page 74

Using multi-zone configuration
Analog audio signals only
DVD player etc.
Infrared signal
emitter
Main zone
From the REMOTE OUT jack
Using the internal amplifiers of this unit
Important safety notice
The EXTRA SP terminals of this unit should not be connected to a Passive Loudspeaker Selector Box or more than
one loudspeaker per channel.
Connection to a Passive Loudspeaker Selector Box or multiple speakers per channel could create an abnormally low
impedance load resulting in amplifier damage. See this owner's manual for correct usage.
Compliance with minimum speaker impedance information for all channels must be maintained at all times. This
information is found on the back panel of your unit.
If you want to use one internal amplifier of this unit
Connect the Zone 2 speakers directly to the SP1 terminals and then set "Extra Speaker Assignment" to "Zone2"
(page 60)
If you want to use two internal amplifiers of this unit
Connect the Zone 2 and Zone 3 speakers directly to the SP1 and SP2 terminals and then set "Extra Speaker Assignment"
to "Zone2 + Zone3" (page 60).
Zone2 speakers
y
• You can use the speakers connected to EXTRA SP (SP1/SP2) terminals as the front speaker system of another zone.
• When you use the internal amplifiers for the Zone2/3 speakers, you can adjust the volume level and set the initial volume and maximum volume of the
Zone2/3 speakers (page 64).
70
En
From the ZONE2 OUT jacks
This unit
MAIN
ZONE 3
ZONE 2
SP1
ZONE2/PRESENCE
From the ZONE3 OUT jacks
Amplifier
Remote control
Infrared signal
receiver
Second zone
(Zone 2)
To the REMOTE IN jack
SP2
Zone3 speakers
ZONE3
This unit
Amplifier
Third zone
(Zone 3)