Continuous Play - Aiwa CX-NMT50 Operating Instructions Manual

MUSIIC SENSOR
If there is a 4-second or longer blank between each track, a
search for the beginning of the current or next track during
playback can be done easily.
Press the + or > button during playback referring to the
playback side indicator (4 or b) on the display.
For example, when the - button is pressed while E is
displayed, playback of the next track starts.
Music sensor function may not be able to detect tracks under
the following conditions:
c Blanks of less than 4 seconds between tracks
Noisy blanks
Long passages of low-end sound
Low c,verall recording levels
CONTINUOUS PLAY
"1
u
After playback on one deck finishes, the tape in the other deck
will start to play without interruption,
1
2
3
4
Insert
tapes into deck 1 and
deck 2.
Press the TAPE/DECKl/2 button to select the
deck to be played back first.
Press the REV MODE button to select 11.
Press the +> button to start playback.
Playback continues until the button is pressed.
.
About cassette tapes
To prevent accidental erasure, break off the plastic tabs
on the cassette tape after recording with a screwdriver or
other pointed tool.
Side A
~o
_
(q
\ Q@
;a
\
*
Type II tape
Tab for side A
detection
slot
L J
To record on the tape again, cover the tab openings with
adhesive tape, etc. (On Type II tapes, take care not to
cover the Type II tape detection slot.)
120-minute or longer tapes are extremely thin and easily
deformed or damaged. They are not recommended.
Take up any slack in the tape with a pencil or similar tool
before use. Slack tape may break or jam in the mechanism,
—
EAfGL/SH I :?