Recording; Basic Recording - Aiwa CX-NMT50 Operating Instructions Manual

BASIC RECORDING
INSERTING BLANK SPACES
This section explains how to record from the tuner, CD player, or
external equipment.
Preparation
Set the tape to the point where recording will start.
Use Type I (normal) and Type II (high/CrOz) tapes for recording.
1
2
3
4
Insert the tape to be recorded on into deck 2.
Insert the tape with the side to be recorded on first facing
out from the unit.
Press the REV MODE button to select the reverse
mode.
To record on one side only, select =.
To record on both sides, select => or C=).
Press one of the function buttons and prepare
the source to be recorded.
To record from a CD, press the CD button and load the
disc(s).
To record from a radio broadcast, press the TUNER button
and tune in to a station.
To record from a connected source, press the VIDEO/AUX
or MD button and play.
Press the REC/REC MUTE button to start
recording.
When the selected function is CD, playback and recording
start simultaneously.
To stop recording, press the button.
To pause recording, press the 11 button. (Applicable when the
source is TUNER, VI DEO/AUX or MD.) To resume recording,
press again.
Insertion of 4-second blank spaces enables you to activate the
Music Sensor function. (Applicable when the source is TUNER,
VIDEO/AUX or MD.)
1 Press the . REC/REC MUTE button during recording or
while in recording pause mode.
~ on the display flashes for 4 seconds and the tape runs
without recording. After 4 seconds, the deck enters the
recording pause mode.
2 Press the II button to resume recording.
To insert a blank space of less than 4 seconds, press the
REC/REC MUTE button again while ~ is flashing.
To insert blank spaces of more than 4 seconds, after the
deck enters recording pause mode, press the REC/REC
MUTE button again. Each time the button is pressed, a 4-second
blank space is added.
To erase a
recording
Make sure the microphone is not connected to this unit.
1
2
3
4
Insert the tape to be erased into deck 2 and press the TAPEI
DECK 1/2 button to display 'rTP 2".
Set the tape to the point where the erasure is to be started.
Set the reverse mode by pressing the REV MODE button.
Press the REC/REC MUTE button to start the erasure.
I3
ENGLISH