Advanced Cd Playback - Sharp CD-BA300 Operation Manual

Advanced CD playback (continued)
7
Press the 0/R 0/R (0 R 0 R) button to start playback.
0/R 0/R 0/R 0 R 0 R 0 R
Playback will begin from track 1 on
After that disc finishes playing, the next disc will automatically play.
When the last track on the third disc has finished playing, the CD player will
stop automatically.
When there is no CD in one of the disc 1 - 3 positions, that position will be
skipped and the next CD will be played.
To interrupt playback:
Press the CD 6 button on the remote control.
To resume playback from the same point, press the 0 R button.
To stop playback:
Press the (CD ) button.
To remove the CDs:
While in the stop mode, press the 7 OPEN/CLOSE button.
The disc tray will open. Remove the two discs. Then, press the DISC SKIP button to
rotate the disc tray and remove the remaining disc.
After use:
Press the ON/STAND-BY button to enter the power stand-by mode.
Caution:
Do not place two CDs in one disc tray.
Do not push the disc tray while it is moving.
Do not turn the disc tray by hand. This may cause malfunctions.
If the power fails while the tray is open, wait until the power is restored.
If the disc tray is stopped forcibly, "ER-CD10" will appear in the display and the unit
will not function.
If this occurs, press the ON/STAND-BY button to enter the stand-by mode and then
turn the power on again.
If TV or radio interference occurs during CD operation, move the unit away from the
TV or radio.
If a disc is damaged, dirty, or loaded upside down, the disc will be skipped.
*BA300_P16_17 17
the disc you have selected to play.
To locate the beginning of a track
To move to the beginning of the next track:
Press the W PRESET 2 4 button for less than 0.5 seconds during
playback.
You can skip to any track by pressing the W PRE-
SET 2 4 button repeatedly until the desired
track number appears.
To restart the track being played:
Press the 5 3 PRESET X button for less than 0.5 seconds during
playback.
You can skip to any track by pressing the
5 3 PRESET X button repeatedly until the
desired track number appears.
Notes:
You can locate the beginning of a track on a single disc only.
The 3 / 5 or 2 / 4 button on the remote control allows you to locate the
beginning of a track.
To locate the desired portion
For audible fast forward:
Press and hold down the W PRESET 2 4 button during playback.
For audible fast reverse:
Press and hold down the 5 3 PRESET X button during playback.
Notes:
Normal playback will resume when the 5 3 PRESET X or W PRESET 2 4
button is released.
You can locate the desired portion on a single disc only.
When the end of the last track is reached during fast forward, "END" will appear in
the display and CD operation will be paused. When the beginning of the first track
is reached during fast reverse, the unit will enter the playback mode.
The 3 / 5 or 2 / 4 button on the remote control allows you to locate the
desired portion.
00.11.16, 2:50 PM
17