Listening To The Radio - Sharp CD-BA300 Operation Manual

Listening to the Radio

20
Sound Control (See page 14)
*BA300_P20_21 20
1
Press the ON/STAND-BY button to turn the power on.
2
Press the TUNER (BAND) button repeatedly to select the desired
frequency band (FM or AM).
3
Press the TUNING/TIME (X X X X X or W W W W W ) button to tune in to the desired
station.
Manual tuning:
Press the TUNING/TIME button as many times as required to tune in to the
desired station.
Auto tuning:
When the TUNING/TIME button is pressed for more than 0.5 seconds, scan-
ning will start automatically and the tuner will stop at the first receivable broad-
cast station.
Notes:
When radio interference occurs, auto scan tuning may stop automatically at
that point.
Auto scan tuning will skip weak signal stations.
To stop the auto tuning, press the TUNING/TIME button again.
To receive an FM stereo transmission:
Press the TUNER (BAND) button so that the "ST" indicator lights up.
"j" will appear when an FM broadcast is in stereo.
If the FM reception is weak, press the TUNER (BAND) button so that the "ST" indi-
cator goes out. The reception changes to monaural, and the sound becomes clearer.
After use:
Press the ON/STAND-BY button to enter the power stand-by mode.
00.11.16, 2:51 PM
FM stereo mode indicator
FM stereo receiving indicator