Recording From The Radio - Sharp CD-BA300 Operation Manual

Recording from the Radio

Before recording:
When recording important selections, make a preliminary test to ensure that the
desired material is properly recorded.
SHARP is not liable for damage or loss of your recording arising from malfunction of
this unit.
The volume and sound controls can be adjusted with no effect on the recorded
signal (Variable Sound Monitor).
For recording use only normal tape. Do not use metal and CrO
*BA300_P23_25 23
Recording can be operated in the TAPE 2 compartment. The TAPE 1 is for playback
only.
1
Tune in to the desired station. (See page 20.)
2
Load a cassette into the TAPE 2 cassette compartment with the
side to be recorded on facing you.
tapes.
Wind past the leader of the tape, on which recording cannot be performed.
2
3
Press the REC PAUSE I6
Recording will be paused.
4
Press the 0/R 0/R button on the main unit or the TAPE 2 0 0 0 0 0 button
0/R 0/R 0/R
on the remote control to start recording.
To interrupt recording:
Press the REC PAUSE I6 (I6) button.
To resume recording, press 0/R (TAPE 2 0) button.
To stop recording:
Press the (TAPE ) button.
Note:
If you hear a whistling noise while recording an AM station, move the AM loop antenna.
Erase-prevention tab of cassette tapes:
When recording on a cassette tape, make sure
that the erase-prevention tabs are not re-
moved.
Cassettes have removable tabs that prevent
accidental recording or erasing.
To protect the recorded sound, remove the tab
after recording.
Cover the tab hole with adhesive tape to record
on the tape without the tab.
00.11.16, 2:53 PM
I6 (I6 I6) button.
I6 I6 I6 I6
I6 I6
Side A
Tab for side B Tab for side A
Listening to the Radio (See page 20)
23