GE AZ41E09DAB Owner's Manual And Installation Instructions page 15

Installation Instructions
I
MAKE ELECTRICAL CONNECTION TO THE UNIT
m REMOVE JUNCTION BOX
1. Removethejunction box cover by removing the front
two screws.
2. Removethe junction box by removing the top and
bottom rear screws. Note how the tabs on the lower
left side of the junction box serve to hold the side in
place.This will help when the box is being reinstalled.
Unitconnector
Junction
box cover
\Junction
box
Izl CONNECT THE CORDSET
Plug the connector, provided in the Direct Connect Kit,
fully into place in the unit mating connector. Be sure
the locking tabs at the sides are engaged.
NOTE:Order Kit RAK4OO2CW to enable a quick
disconnect inside the junction box.
I
IYJATTACH CONDUIT
1. Usethe round knockout at the bottom of thejunction box
to attach conduit coming from the branchcircuit.
Removethe knockout,attach the conduit and bringwires
into thejunction box. Leave6" of wire free at the end of
the conduit to allow connectionsto be made.
2. If a fuse and fuseholder are to be used, the
knockout at the top of the box isfor mounting
a Bussfuseholder. Be sure the fuse and fuseholder
ore of the same rating as the branch circuit.
Leadwires at the fuse can be either soldered in place
or attached using UL-listed 1/4" female (receptacle)
crimp connectors. Follow local codes.
_-I REINSTALL JUNCTION BOX
• Reinstallthe junction box by engaging the left tabs
on the lower right face of the unit, aligning the screw
holes at the top and bottom and driving the two
screws until secure. Be sure that all wire leads are
inside the box and not pinched between the box and
the unit. The green insulated ground wire from the unit
MUSTbe connected to the branch circuit ground wire.
Make all wire connections by using appropriate
UL-listed electrical connectors and techniques
(black to black, white to white and green to green).
[] REINSTALLJUNCTION BOX COVER
1. Carefully tuck all wires and connections back inside
the junction box. Be sure there are no loose
connections or stray uninsulated wires exposed.
2. Placethe junction box cover in place. Replacethe two
screws removed earlier and tighten securely.
15