ASROCK X58 EXTREME Installation Manual page 22

CrossFire Bridge
Step 3. Connect the DVI monitor cable to the DVI connector on the Radeon graphics
card on PCIE2 slot. (You may use the DVI to D-Sub adapter to convert the
DVI connector to D-Sub interface, and then connect the D-Sub monitor
cable to the DVI to D-Sub adapter.)
2.6.2 Driver Installation and Setup 2.6.2 Driver Installation and Setup 2.6.2 Driver Installation and Setup
2.6.2 Driver Installation and Setup 2.6.2 Driver Installation and Setup
Step 1. Power on your computer and boot into OS.
Step 2. Remove the ATI
The Catalyst Uninstaller is an optional download. We recommend using this
utility to uninstall any previously installed Catalyst drivers prior to installation.
Please check AMD website for ATI
Step 3. Install the required drivers to your system.
For Windows
A. ATI TM recommends Windows
installed (If you have Windows
in your system, there is no need to download it again):
http://www.microsoft.com/windowsxp/sp2/default.mspx
B. You must have Microsoft .NET Framework installed prior to
downloading and installing the CATALYST Control Center. Please
check Microsoft website for details.
For Windows
Install the CATALYST Control Center. Please check AMD website for details.
Step 4. Restart your computer.
Step 5. Install the VGA card drivers to your system, and restart your computer.
Then you will find "ATI Catalyst Control Center" on your Windows
(Driver Version: 8-12_vista32_dd_ccc_wdm_enu_72275.exe)
ATI Catalyst Control Center
2 2 2 2 2 2
2 2 2 2
TM driver if you have any VGA driver installed in your system.
TM
driver updates.
® XP OS:
® XP Service Pack 2 or higher to be
® XP Service Pack 2 or higher installed
® TM
Vista OS:
ASRock X58 Extreme Motherboard
® taskbar.