Chipset Configuration - ASROCK 4CORE1333-VIIV - V1.0 User Manual

3.3.2 Chipset Configuration

3.3.2 3.3.2 Chipset Configuration Chipset Configuration Chipset Configuration
3.3.2 3.3.2 Chipset Configuration
BIOS SETUP UTILITY
Advanced
Chipset Configuration
Memory Remap Feature
DRAM Frequency
Flexibility Option
Configure DRAM Timing by SPD
DRAM CAS# Latency
Primary Graphics Adapter
OnBoard HD Audio
Front Panel
CD-In
OnBoard Lan
OnBoard 1394
VCCM Voltage
VDDQ Voltage
ICH8 Voltage
v02.54 (C) Copyright 1985-2005, American Megatrends, Inc.
Memory Remap Feature
Use this item to enable or disable memory remap feature. Configuration
options: [Enabled] and [Disabled]. The default value is [Disabled].
DRAM Frequency
If [Auto] is selected, the motherboard will detect the memory module(s)
inserted and assigns appropriate frequency automatically. You may also
select other value as operating frequency: [266MHz (DDRII533)], [333MHz
(DDRII667)], [400MHz (DDRII800)].
Flexibility Option
The default value of this option is [Disabled]. It will allow better tolerance for
memory compatibility when it is set to [Enabled].
Configure DRAM Timing by SPD
Select [Enabled] will configure the following items by the contents in the
SPD (Serial Presence Detect) device. If you select [Disabled], you will find
the items "DRAM RAS# to CAS# Delay", "DRAM RAS# Precharge", and
"DRAM RAS# Activate to Precharge" appear to allow you adjusting them.
DRAM CAS# Latency
Use this item to adjust the means of memory accessing.
DRAM RAS# to CAS# Delay
This controls the latency between the DRAM active command and the
read / write command. Configuration options: [2 DRAM Clocks], [3 DRAM
Clocks], [4 DRAM Clocks], [5 DRAM Clocks], and [6 DRAM Clocks].
DRAM RAS# Precharge
This controls the idle clocks after a precharge command is issued.
Configuration options: [2 DRAM Clocks], [3 DRAM Clocks], [4 DRAM
Clocks], [5 DRAM Clocks], and [6 DRAM Clocks].
ENABLE: Allow
remapping of
[Disabled]
overlapped PCI memory
[Auto]
above the total
[Disabled]
physical memory.
[Enabled]
[Auto]
DISABLE: Do not allow
remapping of memory.
[PCI]
[Auto]
Select Screen
[Auto]
Select Item
[Enabled]
+ - Change Option
[Enabled]
F1 General Help
[Enabled]
F9 Load Defaults
F10 Save and Exit
[Auto]
ESC Exit
[Low]
[Low]
5 6 5 6 5 6
5 6 5 6