Table of Contents
Advertisement
Step 1.
Adjust the jumpers on this motherboard to enable AGI Express slot
(PCI Express x4). Please refer to the pictures below for proper jumper
setting.
Step 2.
Connect to the system power supply. Please connect a hard disk power
connector to SLI/XFIRE Power connector on this motherboard.
It is recommended to use 500-Watt power supply or greater
to perform the benefit of CrossFire
X850XT, X1900 and X1950 series.
Step 3.
Install the standard Radeon (CrossFire
Express slot (PCI Express x4). For the proper installation procedures,
please refer to section "Expansion Slots".
Standard Radeon
(CrossFire
graphics card
Step 4.
Install the Radeon CrossFire
proper installation procedures, please refer to section "Expansion Slots".
Radeon CrossFire
Edition graphics card
Standard Radeon
(CrossFire
graphics card
1. You are allowed to install two CrossFire
may use one CrossFire
(CrossFire
Ready) graphics card from the same series.
TM
2. For ATI
Radeon X1300, X1600, X1650 and X1950Pro series, there are no CrossFire
TM
Edition graphics cards. You can still install two regular graphics cards from the same
series on PCIE2 slot and AGI Express slot (PCI Express x4) to support CrossFire
Besides, please connect the monitor cable to the graphics card on PCIE2 slot.
PCIEX1_EN1-5: Short Pin1, Pin2
feature for Radeon
TM
Ready) graphics card to AGI
TM
Ready)
TM
Edition graphics card to PCIE2 slot. For the
TM
TM
Ready)
TM
Edition graphics cards to both slots, or you
TM
Edition graphics cards and a compatible standard Radeon
TM
2 6
2 6
2 6
2 6
2 6
TM
.
TM
Advertisement
Table of Contents
