Onboard Headers And Connectors - ASROCK 4CORE1333-VIIV - V1.0 User Manual

2.11 Onboard Headers and Connectors

2.11 Onboard Headers and Connectors 2.11 Onboard Headers and Connectors
2.11 Onboard Headers and Connectors 2.11 Onboard Headers and Connectors
Onboard headers and connectors are NOT jumpers. Do NOT place
jumper caps over these headers and connectors. Placing jumper caps
over the headers and connectors will cause permanent damage of the
motherboard!
FDD connector
(33-pin FLOPPY1)
(see p.11 No. 30)
Pin1
Note: Make sure the red-striped side of the cable is plugged into Pin1 side of the
connector.
Primary IDE connector (Blue)
(39-pin IDE1, see p.11 No. 10)
connect the blue end
to the motherboard
80-conductor ATA 66/100 cable
Note: Please refer to the instruction of your IDE device vendor for the details.
Serial ATAII Connectors
(SATAII_1 (Port0): see p.11, No. 16)
(SATAII_2 (Port1): see p.11, No. 17)
(SATAII_3 (Port2): see p.11, No. 19)
(SATAII_4 (Port3): see p.11, No. 21)
(SATAII_5 (Port4): see p.11, No. 15)
(SATAII_6 (Port5): see p.11, No. 22)
SATAII_6 (Port5) connector can be used for internal storage device or
be connected to eSATAII connector to support eSATAII device. Please
read "eSATAII Interface Introduction" on page 38 for details about eSATAII
and eSATAII installation procedures.
FLOPPY1
IDE1
PIN1
These six Serial ATAII (SATAII)
connectors support SATA data
cables for internal storage
SATAII_5 (Port4) SATAII_1 (Port0)
devices. The current SATAII
interface allows up to 3.0 Gb/s
SATAII_2 (Port1)
SATAII_6 (Port5)
data transfer rate.
SATAII_3 (Port2)
SATAII_4 (Port3)
3 1 3 1 3 1
3 1 3 1
the red-striped side to Pin1
connect the black end
to the IDE devices