Omron ZS Command Reference Manual page 2

Introduction
Thank you for purchasing the ZS Series.
This manual provides reference information on non-procedural communication commands
for ZS Series.
This manual provides information for the following models and versions.
Model
ZS-LDC
ZS-HLDC
ZS-MDC
ZS-DSU
Different firmware versions may cause communication errors, unintended setting
overwrite, and damages on the controller. Please make sure to use the controller with the
correct software version.
If your software version is not listed in the table above, please update the software using
the SmartMonitorZS firmware update software, such as WarpEngineZS, to match the
software version.
When using the ZS Series, be sure to observe the following:
• The ZS Series must be operated by personnel knowledgeable in electrical engineer-
ing.
• To ensure correct use, please read this manual thoroughly to deepen your under-
standing of the product.
• Please keep this manual in a safe place so that it can be referred to whenever neces-
sary.
Firmware Version
v2.000 or later
v1.000 or later
v2.000 or later
v2.000 or later