Omron SFC - INTRODUCTION GUIDE Introduction Manual page 31

4 Create the remaining steps and
transitions.
Create all the other remaining steps and
transitions.
For details on steps and transitions to be
created, refer to 2-2-3 Programming Example.
5 Assign all transition programs.
In this example, inputs from sensors are used
as transition conditions.
Assign transition programs to the transitions,
in the same manner that the Vehicle
Detected program was assigned to the
Vehicle Detection Flag transition.
For details on transition programs to be
created, refer to 2-2-3 Programming Example.
Sensor inputs can also be assigned to
transitions as Boolean variable addresses.
For example, the input contact (0.00) for the
Vehicle Sensor can be assigned directly to the
Vehicle Detection Flag transition.
2-5 Creating Steps and Transitions
2
2-21