Batteries - Omron NSA12-15-TX11B User Manual

5-1-4 Batteries

One lithium battery on the motherboard and another on the RAS board are used to
back up the calendar, clock, and log data. The service life of these batteries is
approximately five years in an operating environment maintained at 25°C and is
shorter in environments with a higher ambient temperature. Replace the batteries
periodically depending on the operating environment.
Motherboard battery: NSA-BAT03
RAS board battery: NSA-BAT03
Guidelines for Replacing Batteries
The guidelines for replacing lithium batteries are as follows:
•
•
• Dispose of any battery that has been dropped on the floor or otherwise subjected to
Note
excessive shock, as this may cause the battery fluid to leak.
• Make sure you have the correct type of battery and that you install it properly.
• Replace the battery yourself.
• Operation may not be normal if a battery other than the specified battery is used.
Procedure for Replacing Batteries
Connector
RAS board battery
Changing the RAS Board Battery
1. Backup the maintenance status data held in the RAS board.
Refer to C:\Program Files\OMRON\tools\readme.html for the backup
procedure for maintenance status data on the RAS board.
2. Remove the back cover. (Refer to 3-3-1 Installing a PCI Board.)
3. Remove the RAS board battery from the clamps, and then unhook the
connectors.
4. Replace the battery, and then assemble the unit in the reverse order.
5. Register the maintenance status data in the RAS board.
Refer to C:\Program Files\OMRON\tools\readme.html for the registration
procedure for maintenance status data in the RAS board.
Five years have elapsed since a new battery was installed.
The BATLOW indicator on the RAS Board is lit (the RAS Board battery
only).
5-1 Maintenance
5-1-4 Batteries
Connector
Motherboard battery
5
5-3