Installing The Nsa-Series Industrial Pc In A Control Panel - Omron NSA12-15-TX11B User Manual

3-4-2 Installing the NSA-series Industrial PC in a Control Panel

The NSA-series Industrial PC is normally mounted in a panel. Follow the steps
below to mount the Unit.
1. Cut the mounting hole out from the panel.
Panel thickness: 1.6 to 4.0 mm
2. Insert the NSA-series Industrial PC into the hole from the front of the panel.
3. Use the Mounting Brackets provided to secure the NSA-series Industrial PC in
the panel. Tighten the Mounting Brackets evenly to the specified torque.
Failure to do so may cause the front sheet to buckle.
Tightening torque: 0.5 to 0.6 N·m
3-4 Installing the NSA-series Industrial PC
3-4-2 Installing the NSA-series Industrial PC in a Control Panel
3
3-13