Uninstalling; Installing Usb Drivers For Ns-Series Pts - Omron NS-CXDC1-V3 User Manual

Uninstalling

2-3 Uninstalling
Operation Procedure
1,2,3...
2-4

Installing USB Drivers for NS-Series PTs.

Note
Applicable Operating
Systems
Operation Procedure
1,2,3...
18
1. To uninstall the CX-Designer, click the Windows Start Button and select
Settings - Control Panel.
2. Double-click Add/Remove Applications.
3. Select CX-Designer_V @ . @ from the list and click the Edit/Delete Button
("@.@" represent the version number.) Follow the instructions displayed in
the window messages to uninstall the CX-Designer.
4. When uninstalling the CX-Designer has been finished, a message will be
displayed indicating that the uninstall operation has been completed.
Check the message and then click the Finish Button.
Install the NS-series USB driver in the personal computer. After installation,
data can be transferred between the personal computer and NS-series PT via
USB.
(1) With NS-V1 Series models, make sure that the PT has a lot number that
supports USB transmission. The system program version of the NS-se-
ries PT must also support USB transmission. For details, refer to 3-3-2
Connecting via USB in the NS series Setup Manual (Cat. No. V083).
(2) If an NS-series USB driver has already been installed for use with the NS-
Designer, the NS-series USB driver must be installed again to use the
CX-Designer.
(3) Do not install the NS-series USB driver for the NS-Designer while the CX-
Designer is being used.
Windows 2000, Windows XP, and Windows Vista
1. Start Windows 2000, Windows XP, or Windows Vista.
2. Connect the personal computer to the NS-series PT USB slave connector
using the USB cable. The following Found New Hardware Wizard will be
displayed.
Section 2-3