Omron NS-CXDC1-V3 User Manual page 66

Creating Screens Using Symbols
1,2,3...
1,2,3...
44
The same symbol as the CX-Programmer
symbol is added.
Note To use tags (network symbols), the same tags must be registered in both the
PT and the host. If tags are added or changed in either the CX-Designer or
CX-Programmer, copy them to the other one. Tags are supported by CX-Pro-
grammer 8.0 or higher.
Procedure
Copying CX-Programmer Symbols to the CX-Designer
1. Start CX-Programmer and open the project with the symbol to be shared.
2. Select the symbol from the CX-Programmer symbol table.
3. Open the CX-Designer symbol table and paste the symbol.
4. If a host address is set for the symbol, select the applicable host for the
destination.
Copying CX-Designer Symbols to the CX-Programmer
1. Select the symbol from the CX-Designer symbol table and copy it to the
CX-Programmer.
2. Open the CX-Programmer symbol table and paste the symbol.
The same symbol as the CX-Designer symbol is added.
CX-Programmer symbols are copied and
pasted to the CX-Designer symbol table.
Section 4-1