Omron DeviceNet Safety NE0A Series Operation Manual page 193

DeviceNet Explicit Messages
Data
Read data is included only when a read command is executed.
Error Code
The explicit message error code. For details, refer to the list of error codes in the following table.
Error Codes
Code Error name
08FF Service not supported
09FF Invalid attribute value
16FF Object does not exist
15FF Too much data
13FF Not enough data
0CFF Object state conflict
20FF Invalid parameter
0EFF Attribute not settable
10FF Device state conflict
14FF Attribute not supported
19FF Store operation failure
2AFF Group 2 only server
general failure
168
The service code is incorrect.
The specified attribute value is not supported.
The data written was outside the valid range.
The specified Instance ID is not supported.
The data is larger than the specified size.
The data is smaller than the specified size.
The specified command cannot be executed due to an internal error.
The specified operation command data is not supported.
An attribute ID supported only for reading has been executed for a write service
code.
The specified command cannot be executed due to an internal hardware error.
The specified attribute is not supported.
The data cannot be stored in memory.
The specified command or attribute is not supported or the attribute was not set.
Cause
Appendix B